{"product_id":"handmade-wooden-feet-for-cutting-board-set-of-4-copy","title":"Handmade Metal Feet for Cutting Board - Set of 4","description":"\u003cp\u003e\u003cspan\u003eBoardsmith non-slip cutting board feet are comprised of two parts: an outer stainless steel escutcheon and an inner polyurethane foot or bumper that nests inside the escutcheon. The feet set also includes four, #10, pan-head stainless steel screws. Unlike normal coated screws, stainless steel screws will not rust with prolonged exposure to moisture.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003eDue to the lower profile, these will still provide the same great stability as our normal feet but will allow shorter individuals to chop more comfortably.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003eThe total height of the metal cutting board feet and escutcheons is approximately 1\/2\" tall.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003eWritten instructions:\u003cbr\u003e1) Mark the screw hole locations on the bottom of the butcher block. I normally recommend around 1 1\/2\" in from each corner. If it's a small cutting board like a sidekick, go closer to the outer corner. \u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003e2) Using a 5\/32\" drill bit, pre-drill a 1\/2\" deep hole at each screw location. You can also use a 1\/8\" (tight fit) or a 9\/64\" bit (snug fit), but 5\/32\" tends to work best.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003e3) Using the same bit, pre-drill through the center of each polyurethane bumper. This isn't critical, but it makes installation easier.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003e4) Using a regular Phillips head screwdriver, thread the screw through the foot and escutcheon until the screw tip is protruding.\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003e5) place the screw tip into the pre-drilled hole in the cutting board and hand tighten until the wooden escutcheon no longer turns freely. Make sure you don't overtighten and drive the screw all the way through the polyurethane foot.\u003c\/span\u003e\u003c\/p\u003e","brand":"The Boardsmith","offers":[{"title":"Stainless Steel","offer_id":53447036764457,"sku":"FEET-SS","price":30.0,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0415\/5218\/3446\/files\/BRD_Stainless_Feet-White-Web-1x1.jpg?v=1787574672","url":"https:\/\/theboardsmith.sbs\/products\/handmade-wooden-feet-for-cutting-board-set-of-4-copy","provider":"The Boardsmith","version":"1.0","type":"link"}